Skip to Content

Changes for page Power controller

Last modified by Mathias Larsen on 2026/09/24 21:21
From version 9.1
edited by Mathias Larsen
on 2026/05/25 12:14
Change comment: There is no comment for this version
To version 12.1
edited by Mathias Larsen
on 2026/05/25 16:46
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -2,7 +2,7 @@
2 2  
3 3  == Microcontroller Pinout ==
4 4  
5 -The power controller uses a microcontroller to control the pumps, fans, buzzer, and brake light. It also features current monitoring and LED indicators. The Microcontroller used in this system is STM32G431CBT6 D
5 +The power controller uses a microcontroller to control the pumps, fans, buzzer, and brake light. It also features current monitoring and LED indicators. The Microcontroller used in this system is STM32G431CBT6
6 6  
7 7  
8 8  |=Physical pin|=Electrical pin|=(((
... ... @@ -34,18 +34,18 @@
34 34  |30|PA8|Digital output Enable buzzeer
35 35  |31|PA9|Digital output Enable brake light
36 36  |32|PA10|Input ASMS signal
37 -|33|PA11|CAN bus RXD
38 -|34|PA12|CAN bus TXD
37 +|33|PA11|CAN-BUS RXD
38 +|34|PA12|CAN-BUS TXD
39 39  |35|VSS|Voltage source: Ground
40 40  |36|VDD|Voltage source: Power (+3V3)
41 41  |37|PA13|SWDIO
42 42  |38|PA14|SWCLK
43 -|40|PB3|LED 3
44 -|41|PB4|LED 4
45 -|42|PB5|LED 5
46 -|43|PB6|Enable Pump 1
47 -|44|PB7|Enable Pump 2
48 -|45|PB8|LED 6
43 +|40|PB3|Digital output: LED 3
44 +|41|PB4|Digital output: LED 4
45 +|42|PB5|Digital output: LED 5
46 +|43|PB6|Digital output: Enable Pump 1
47 +|44|PB7|Digital output: Enable Pump 2
48 +|45|PB8|Digital output: LED 6
49 49  |46|PB9|LED 7
50 50  |47|VSS|Voltage source: Ground
51 51  |48|VDD|Voltage source: Power (+3V3)