Skip to Content

Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 11.3
edited by Heimir Thordarson
on 2026/01/21 13:50
Change comment: There is no comment for this version
To version 11.1
edited by Heimir Thordarson
on 2026/01/21 13:47
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -13,11 +13,10 @@
13 13  
14 14  = Wiring Diagram =
15 15  
16 -In the following section, how the sensor module is connected will be covered. The connector for the sensor module is a [[High-Density d'sub-44>>https://www.te.com/en/product-2311770-1.html]] which is directly solderen onto the circuit board. The plug needed for this system is the [[204517-3>>doc:Sandbox.TestPage3]], which uses crimps instead of solder cups which is common for the dsub connectors
16 +In the following section, how the sensor module is connected will be covered. The connector for the sensor module is a [[High-Density d'sub-44>>https://www.te.com/en/product-2311770-1.html]] which is directly solderen onto the circuit board.
17 17  
18 -[[image:AR26_ASM pinout.png||height="221" width="469"]]
18 +[[image:AR26_ASM pinout.png]]
19 19  
20 -In the figure above, th
21 21  
22 22  == Typical Application ==
23 23