Changes for page Sensor Module

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -68,40 +68,12 @@
68	68	(% class="wikigeneratedid" %)
69	69	As shown in the figure above, the thermistor is put into a voltage divider circuit with a 4k7 ohm resistor to convert the resistance changes of the thermistor to a measurable voltage. To find the temperature of the thermistor based on the voltage measure by the analog-to-digital converter (adc), the resistance of the thermistor needs to be calculated based on the voltage from a voltage divider.
70	70
71		-{{mathjax}}
72		-(% style="font-size: 1.5em;" %) ((( {{mathjax}}
	71	+(% style="font-size: 1.5em;" %) ((({{mathjax}}
73	73	$$
74	74	R_T = R_f \frac{V_{out}}{V_{in} - V_{out}}
75	75	$$
76		-{{mathjax}} )))
77		-{{/mathjax}}
	75	+{{/mathjax}})))
78	78
79		-(% class="wikigeneratedid" %)
80		-where:
81	81
82		-* {{mathjax}}$$R_f$${{/mathjax}} = The resistance of the upper resistor, which in this case is 4.7k Ohms
83		-* {{mathjax}}$$V_{out}$${{/mathjax}} = Voltage measured by the microcontroller
84		-* {{mathjax}}$$V_{in}$${{/mathjax}} = Supply voltage of the voltage divider, which in this case is 3.3 Volts
85		-* {{mathjax}}$$R_T$${{/mathjax}} = Resistance of the thermistor in Ohms
86		-
87		-The resistance R_T can then be put into this
88		-
89		-=== Suspension Displacement Sensor ===
90		-
91		-=== Oil Temperature Sensor ===
92		-
93		-=== Cooling Sensor ===
94		-
95		-= Design =
96		-
97		-== Schematics ==
98		-
99		-== Mechanical ==
100		-
101		-== Bill of Materials ==
102		-
103		-= Cost =
104		-
105		-= FAQ =
106		-
	78	+(% class="wikigeneratedid" %)
107	107