Skip to Content

Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 26.1
edited by Heimir Thordarson
on 2026/01/22 13:48
Change comment: There is no comment for this version
To version 19.2
edited by Heimir Thordarson
on 2026/01/22 13:31
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -68,11 +68,38 @@
68 68  (% class="wikigeneratedid" %)
69 69  As shown in the figure above, the thermistor is put into a voltage divider circuit with a 4k7 ohm resistor to convert the resistance changes of the thermistor to a measurable voltage. To find the temperature of the thermistor based on the voltage measure by the analog-to-digital converter (adc), the resistance of the thermistor needs to be calculated based on the voltage from a voltage divider.
70 70  
71 -(% style="font-size: 1.25em;" %)
72 -(((
73 73  {{mathjax}}
74 74  $$
75 75  R_T = R_f \frac{V_{out}}{V_{in} - V_{out}}
76 76  $$
77 77  {{/mathjax}}
78 -)))
76 +
77 +(% class="wikigeneratedid" %)
78 +where:
79 +
80 +* {{mathjax}}$$R_f$${{/mathjax}} = The resistance of the upper resistor, which in this case is 4.7k Ohms
81 +* {{mathjax}}$$V_{out}$${{/mathjax}} = Voltage measured by the microcontroller
82 +* {{mathjax}}$$V_{in}$${{/mathjax}} = Supply voltage of the voltage divider, which in this case is 3.3 Volts
83 +* {{mathjax}}$$R_T$${{/mathjax}} = Resistance of the thermistor in Ohms
84 +
85 +The resistance R_T can then be put into this
86 +
87 +=== Suspension Displacement Sensor ===
88 +
89 +=== Oil Temperature Sensor ===
90 +
91 +=== Cooling Sensor ===
92 +
93 += Design =
94 +
95 +== Schematics ==
96 +
97 +== Mechanical ==
98 +
99 +== Bill of Materials ==
100 +
101 += Cost =
102 +
103 += FAQ =
104 +
105 +