Skip to Content

Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 42.3
edited by Heimir Thordarson
on 2026/01/27 14:36
Change comment: There is no comment for this version
To version 42.2
edited by Heimir Thordarson
on 2026/01/26 18:19
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -112,8 +112,10 @@
112 112  Where:
113 113  
114 114  * {{mathjax}}\(F_c\){{/mathjax}} = Cut-off frequency of the filter. Any noise with a frequency above this will be filtered out.
115 -* {{mathjax}}\(R\){{/mathjax}} = Resistance of the resistor in low-pass filter.
116 -* {{mathjax}}\(C\){{/mathjax}} = Capacitance of the capacitor in the low-pass filter.
115 +* {{mathjax}}\(R\)
116 +{{/mathjax}} = Resistance of the resistor in low-pass filter.
117 +* {{mathjax}}\(C\)
118 +{{/mathjax}} = Capacitance of the capacitor in the low-pass filter.
117 117  
118 118  Using a resistor with 10k {{mathjax}}\(\Omega\){{/mathjax}} and a capacitor with 100 **nF **in capacitance, the cut-off frequency will be 159 **Hz.**
119 119  
... ... @@ -121,8 +121,6 @@
121 121  
122 122  For AR26, the same sensors from AR25 is reused. These are the [[Texense RSL-A-50-P>>https://cdn.shopify.com/s/files/1/0368/1989/files/technical_datasheet_RSL.pdf?413]] which can be connected as the entire voltage divider when using each end as supply and ground. The output of the sensor will then be the throw of the sensor.
123 123  
124 -[[image:Suspension Displacement Circuit.png]]
125 125  
126 126  
127 -
128 128