Skip to Content

Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 45.2
edited by Heimir Thordarson
on 2026/01/27 15:14
Change comment: There is no comment for this version
To version 46.6
edited by Heimir Thordarson
on 2026/01/27 15:39
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -115,7 +115,7 @@
115 115  * {{mathjax}}\(R\){{/mathjax}} = Resistance of the resistor in low-pass filter.
116 116  * {{mathjax}}\(C\){{/mathjax}} = Capacitance of the capacitor in the low-pass filter.
117 117  
118 -Using a resistor with 10k {{mathjax}}\(\Omega\){{/mathjax}} and a capacitor with 100 **nF **in capacitance, the cut-off frequency will be 159 **Hz.**
118 +Using a resistor with 1k {{mathjax}}\(\Omega\){{/mathjax}} and a capacitor with 100 **nF **in capacitance, the cut-off frequency will be 1592 **Hz.**
119 119  
120 120  == Suspension Displacement Sensor ==
121 121  
... ... @@ -140,4 +140,10 @@
140 140  
141 141  where:
142 142  
143 -* {{mathjax}}\(x\){{/mathjax}} = is the mechanical
143 +* {{mathjax}}\(x\){{/mathjax}} = The mechanical placement excluding the dead length (178mm).
144 +* {{mathjax}}\(V_s\){{/mathjax}} = The supply voltage of the linear potentiometer, in this case it is 3.3 {{mathjax}}\(V\){{/mathjax}}.
145 +* {{mathjax}}\(V_{out}\){{/mathjax}} = The output voltage of the linear potentiometer. ranging from 0.033{{mathjax}}\(V\){{/mathjax}} to 3.267{{mathjax}}\(V\){{/mathjax}}.
146 +
147 +=== Filtering ===
148 +
149 +The sensors output latency can be expected to be a lot shorter than the air temperature sensor as the sensor is just a variable sensor based on placement. The limiting factor for the system which uses this information is the CAN-BUS messages from the inverters which send the information each 6.25 ms