Skip to Content

Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 46.6
edited by Heimir Thordarson
on 2026/01/27 15:39
Change comment: There is no comment for this version
To version 47.1
edited by Heimir Thordarson
on 2026/01/27 17:53
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,4 +1,4 @@
1 -{{wikibox title="Sensor Module" image="https://wiki.alignracing.no/bin/download/Electrical/Sensor%20Module/WebHome/ASM_AR26.png?rev=1.1" caption="3D model of the Sensor Module from Altium Designer" width="25" labelWidth="50"}}
1 +{{wikibox title="Sensor Module" image="https://wiki.alignracing.no/bin/download/Electrical/Sensor%20Module/WebHome/ASM_AR26.png?rev=1.1" caption="3D model of the Sensor Module from Altium Designer" width="30" labelWidth="50"}}
2 2  Voltage = 4.5V - 40V
3 3  Fuse Current = 125mA
4 4  Sensor Inputs = 13
... ... @@ -146,4 +146,8 @@
146 146  
147 147  === Filtering ===
148 148  
149 -The sensors output latency can be expected to be a lot shorter than the air temperature sensor as the sensor is just a variable sensor based on placement. The limiting factor for the system which uses this information is the CAN-BUS messages from the inverters which send the information each 6.25 ms
149 +The sensors output latency can be expected to be a lot shorter than the air temperature sensor as the sensor is just a variable sensor based on placement. The limiting factor for the system which uses this information is the CAN-BUS messages from the inverters which send the information each 6.25 milliseconds. This means that the cut-off frequency cannot be any lower than 160 Hz, which will make the same type of low pass filter from the air temperature sensor acceptable with a cut-off frequency of 1591 Hz.
150 +
151 +== Cooling Sensors ==
152 +
153 +The cooling sensors for the AR26 can is the