Skip to Content

Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 46.7
edited by Heimir Thordarson
on 2026/01/27 15:40
Change comment: There is no comment for this version
To version 46.5
edited by Heimir Thordarson
on 2026/01/27 15:32
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -140,10 +140,10 @@
140 140  
141 141  where:
142 142  
143 -* {{mathjax}}\(x\){{/mathjax}} = The mechanical placement excluding the dead length (178mm).
143 +* {{mathjax}}\(x\){{/mathjax}} = The mechanical placement excluding the dead length.
144 144  * {{mathjax}}\(V_s\){{/mathjax}} = The supply voltage of the linear potentiometer, in this case it is 3.3 {{mathjax}}\(V\){{/mathjax}}.
145 145  * {{mathjax}}\(V_{out}\){{/mathjax}} = The output voltage of the linear potentiometer. ranging from 0.033{{mathjax}}\(V\){{/mathjax}} to 3.267{{mathjax}}\(V\){{/mathjax}}.
146 146  
147 147  === Filtering ===
148 148  
149 -The sensors output latency can be expected to be a lot shorter than the air temperature sensor as the sensor is just a variable sensor based on placement. The limiting factor for the system which uses this information is the CAN-BUS messages from the inverters which send the information each 6.25 milliseconds. This means that the cut-off frequency cannot be any lower than 160Hz, which will make the same type of low pass filter from the air temperature sensor
149 +The sensors output latency can be expected to be a lot shorter than the air temperature sensor as the sensor is just a variable sensor based on placement. The limiting