Changes for page Sensor Module
Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 55.1
edited by Heimir Thordarson
on 2026/01/27 18:03
on 2026/01/27 18:03
Change comment:
There is no comment for this version
To version 55.5
edited by Heimir Thordarson
on 2026/02/09 19:15
on 2026/02/09 19:15
Change comment:
There is no comment for this version
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -161,6 +161,6 @@ 161 161 162 162 The sensors output latency can be expected to be a lot shorter than the air temperature sensor as the sensor is just a variable sensor based on placement. The limiting factor for the system which uses this information is the CAN-BUS messages from the inverters which send the information each 6.25 milliseconds. This means that the cut-off frequency cannot be any lower than 160 Hz, which will make the same type of low pass filter from the air temperature sensor acceptable with a cut-off frequency of 1591 Hz. 163 163 164 -== CoolingSensors==164 +== Gearbox Temperature Sensor == 165 165 166 -The cooli ngsensorsfor theAR26canis the166 +The gearbox Temperature Sensor for AR26 will be the [[GAG10K3976B1>>https://www.te.com/en/product-GAG10K3976B1.html]], a NTC temperature probe which will be installed into a generic M5 bolt which is mounted on the upright in the wheel assembly. The thermistor will be connected in a voltage divider configuration where the ther