Skip to Content

Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 55.5
edited by Heimir Thordarson
on 2026/02/09 19:15
Change comment: There is no comment for this version
To version 55.1
edited by Heimir Thordarson
on 2026/01/27 18:03
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -161,6 +161,6 @@
161 161  
162 162  The sensors output latency can be expected to be a lot shorter than the air temperature sensor as the sensor is just a variable sensor based on placement. The limiting factor for the system which uses this information is the CAN-BUS messages from the inverters which send the information each 6.25 milliseconds. This means that the cut-off frequency cannot be any lower than 160 Hz, which will make the same type of low pass filter from the air temperature sensor acceptable with a cut-off frequency of 1591 Hz.
163 163  
164 -== Gearbox Temperature Sensor ==
164 +== Cooling Sensors ==
165 165  
166 -The gearbox Temperature Sensor for AR26 will be the [[GAG10K3976B1>>https://www.te.com/en/product-GAG10K3976B1.html]], a NTC temperature probe which will be installed into a generic M5 bolt which is mounted on the upright in the wheel assembly. The thermistor will be connected in a voltage divider configuration where the ther
166 +The cooling sensors for the AR26 can is the