Skip to Content

Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 58.3
edited by Heimir Thordarson
on 2026/02/11 19:49
Change comment: There is no comment for this version
To version 60.1
edited by Heimir Thordarson
on 2026/02/18 12:06
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -24,7 +24,7 @@
24 24  
25 25  The Sensor module is designed to measure any extra analog signals rear of the firewall. For AR26, the module is designed to measure two suspension displacement sensors, two oil temperature, four water pressure, four water temperature, and one air temperature sensor. All of the measurements are then transmitted to a CAN network, which there are two of.
26 26  
27 -= Wiring Diagram =
27 += Design =
28 28  
29 29  In the following section, how the sensor module is connected will be covered. The connector for the sensor module is a [[High-Density d'sub-44>>https://www.te.com/en/product-2311770-1.html]] which is directly solderen onto the circuit board. The plug needed for this system is the [[204517-3>>doc:Sandbox.TestPage3]], which uses crimps instead of solder cups which is common for the dsub connectors
30 30  
... ... @@ -207,4 +207,12 @@
207 207  
208 208  The sensors output latency can be expected to be a lot shorter than the oil temperature sensor as the sensor is just a variable sensor based on placement. The limiting factor for the system which uses this information is the CAN-BUS messages from the inverters which send the information each 6.25 milliseconds. This means that the cut-off frequency cannot be any lower than 160 Hz, which will make the same type of low pass filter from the oil temperature sensor acceptable with a cut-off frequency of 1591 Hz.
209 209  
210 += Bill of Materials =
211 +
212 +== Circuit Board ==
213 +
214 +== Wiring Harness ==
215 +
216 +== Sensors ==
217 +
210 210