Skip to Content

Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 64.1
edited by Heimir Thordarson
on 2026/02/26 18:28
Change comment: There is no comment for this version
To version 64.6
edited by Heimir Thordarson
on 2026/03/23 18:48
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -250,6 +250,10 @@
250 250  
251 251  The sensors output latency can be expected to be a lot shorter than the oil temperature sensor as the sensor is just a variable sensor based on placement. The limiting factor for the system which uses this information is the CAN-BUS messages from the inverters which send the information each 6.25 milliseconds. This means that the cut-off frequency cannot be any lower than 160 Hz, which will make the same type of low pass filter from the oil temperature sensor acceptable with a cut-off frequency of 1591 Hz.
252 252  
253 +== Air Temperature Sensor ==
254 +
255 +The main goal of the air temperature sensor is to have an onboard knowledge of the ambient temperature for datalogging and cooling system control system. The sensor is a [[GA10K4D25>>doc:.GA10K4D25.WebHome]] from TE connectivity, which is a NTC thermistor which requires some extra circuitry to ensure that the microcontroller can measure the change in resistance of the thermistor.
256 +
253 253  = Bill of Materials =
254 254  
255 255  == Circuit Board ==