Skip to Content

Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56
From version 64.3
edited by Heimir Thordarson
on 2026/03/23 18:41
Change comment: There is no comment for this version
To version 63.1
edited by Heimir Thordarson
on 2026/02/23 18:01
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -68,8 +68,6 @@
68 68  
69 69  == Microcontroller Pinout ==
70 70  
71 -The sensor module uses a microcontroller to measure and calculate the values for the analog signals. The microcontroller used in this system is the [[STM32G491RET6>>doc:.https\:www\.st\.comenmicrocontrollers-microprocessorsstm32g491re\.html.WebHome]]
72 -
73 73  (% style="width:793.6px" %)
74 74  |=(% style="width: 96px;" %)Physical Pin|=(% style="width: 102px;" %)Electrical Pin|=(% style="width: 593px;" %)Description
75 75  |(% style="width:96px" %)1|(% style="width:102px" %)VBAT|(% style="width:593px" %)Power source from a backup battery if a RTC would be used (Connected to +3V3 in this case)
... ... @@ -196,9 +196,9 @@
196 196  
197 197  where:
198 198  
199 -* {{mathjax}}\(x\){{/mathjax}}= The mechanical placement excluding the dead length (178mm).
197 +* {{mathjax}}\(x\){{/mathjax}} = The mechanical placement excluding the dead length (178mm).
200 200  * {{mathjax}}\(V_s\){{/mathjax}}= The supply voltage of the linear potentiometer, in this case it is 3.3 {{mathjax}}\(V\){{/mathjax}}.
201 -* {{mathjax}}\(V_{out}\){{/mathjax}}= The output voltage of the linear potentiometer. ranging from 0.033{{mathjax}}\(V\){{/mathjax}} to 3.267{{mathjax}}\(V\){{/mathjax}}.
199 +* {{mathjax}}\(V_{out}\){{/mathjax}} = The output voltage of the linear potentiometer. ranging from 0.033{{mathjax}}\(V\){{/mathjax}} to 3.267{{mathjax}}\(V\){{/mathjax}}.
202 202  
203 203  === Filtering ===
204 204  
... ... @@ -250,10 +250,6 @@
250 250  
251 251  The sensors output latency can be expected to be a lot shorter than the oil temperature sensor as the sensor is just a variable sensor based on placement. The limiting factor for the system which uses this information is the CAN-BUS messages from the inverters which send the information each 6.25 milliseconds. This means that the cut-off frequency cannot be any lower than 160 Hz, which will make the same type of low pass filter from the oil temperature sensor acceptable with a cut-off frequency of 1591 Hz.
252 252  
253 -== Air Temperature Sensor ==
254 -
255 -The main goal of the air temperature sensor is to have an onboard knowledge of the ambient temperature for datalogging and cooling system control system.
256 -
257 257  = Bill of Materials =
258 258  
259 259  == Circuit Board ==