Changes for page Sensor Module

Last modified by Heimir Thordarson on 2026/07/05 12:56

From version 66.6

edited by Heimir Thordarson
on 2026/03/24 14:56

Change comment: There is no comment for this version

To version 66.2

edited by Heimir Thordarson
on 2026/03/24 14:39

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -272,22 +272,10 @@
  * {{mathjax}}\(\Delta P\){{/mathjax}} = Pressure difference between the two pressure sensors
  * {{mathjax}}\(\rho\){{/mathjax}} = Density of the cooling liquid
--The sensor used on the AR26 car is the [[Bosch Motorsport PST-F 1>>https://www.bosch-motorsport.de/content/downloads/Raceparts/Resources/pdf/Data%20Sheet_70496907_Pressure_Sensor_Combined_PST-F_1.pdf]] and has the following transfer function for the output voltages based on pressure and temperature.
++The sensor used on the AR26 car is the [[Bosch Motorsport PST-F 1>>https://www.bosch-motorsport.de/content/downloads/Raceparts/Resources/pdf/Data%20Sheet_70496907_Pressure_Sensor_Combined_PST-F_1.pdf]] and has the following
--=== Pressure sensor ===
--The pressure sensor build into the PST-F 1 has an supply voltage of 5 volts and has a output voltage range of 0.5 to 4.5 volts. The following formula shows the pressure based on the output voltage.
--{{mathjax}}
--$$
--P = 2.5 \cdot V - \frac{5}{4}
--$$
--{{/mathjax}}
--
--Where:
--
--* {{mathjax}}\(P\){{/mathjax}} = Pressure f
--
  = Bill of Materials =
  == Circuit Board ==