Wiki source code of Sensor Module
Version 10.5 by Heimir Thordarson on 2026/01/21 13:40
Show last authors
| author | version | line-number | content |
|---|---|---|---|
| 1 | {{wikibox title="Sensor Module" image="https://wiki.alignracing.no/bin/download/Electrical/Sensor%20Module/WebHome/ASM_AR26.png?rev=1.1" caption="3D model of the Sensor Module from Altium Designer" width="22" labelWidth="50"}} | ||
| 2 | Voltage = 4.5V - 40V | ||
| 3 | Max Current = 600mA | ||
| 4 | Sensor Inputs = 13 | ||
| 5 | Voltage divider Inputs = 2 | ||
| 6 | 3V3 Thermistor Inputs = 7 | ||
| 7 | 5V Pressure Inputs = 4 | ||
| 8 | {{/wikibox}} | ||
| 9 | |||
| 10 | = Description = | ||
| 11 | |||
| 12 | The Sensor module is designed to measure any extra analog signals rear of the firewall. For AR26, the module is designed to measure two suspension displacement sensors, two oil temperature, four water pressure, four water temperature, and one air temperature sensor. All of the measurements are then transmitted to a CAN network, which there are two of. | ||
| 13 | |||
| 14 | = Wiring Diagram = | ||
| 15 | |||
| 16 | In the following section, how the sensor module is connected will be covered. The connector for the sensor module is a [[High-Density d'sub-44>>https://www.te.com/en/product-2311770-1.html]] which is directly solderen onto the circuit board. | ||
| 17 | |||
| 18 | [[image:AR26_ASM pinout.png]] | ||
| 19 | |||
| 20 | |||
| 21 | == Typical Application == | ||
| 22 | |||
| 23 | = Design = | ||
| 24 | |||
| 25 | == Bill of Materials == | ||
| 26 | |||
| 27 | = Cost = | ||
| 28 | |||
| 29 | = FAQ = | ||
| 30 | |||
| 31 |