Sensor Module

3D model of the Sensor Module from Altium Designer

Voltage

4.5V - 40V

Fuse Current

125mA

Sensor Inputs

13

Voltage divider Inputs

2

3V3 Thermistor Inputs

7

5V Pressure Inputs

4

Description

The Sensor module is designed to measure any extra analog signals rear of the firewall. For AR26, the module is designed to measure two suspension displacement sensors, two oil temperature, four water pressure, four water temperature, and one air temperature sensor. All of the measurements are then transmitted to a CAN network, which there are two of.

Wiring Diagram

In the following section, how the sensor module is connected will be covered. The connector for the sensor module is a High-Density d'sub-44 which is directly solderen onto the circuit board. The plug needed for this system is the 204517-3, which uses crimps instead of 

Typical Application

Design

Bill of Materials

Cost

FAQ